Instructions / Assembly

A Turn off water (optional).
Flush toilet.
B Disconnect and remove flapper
and handle.
A Push in Blue or Green Release
B Separate Handle or Button
C Twist Upper Housing to unlock
D Pull up from Base to separate
9
10
A B
B
C
D
A
Upper
Housing
Base
Installing the Dual Flush Converter*
If your unit has a button
Blue Push Release
If your unit has a handle
Green Push Release
Color-Coded Blue Rod Color-Coded Green Rod
Quick Flush Quick Flush
Full Flush
Full Flush
Blue Float
Quick Flush
Adjustment
Green Slide
Full Flush
Adjustment
Upper Housing
Base
Cam
Black
Rubber
Ring
Zip Tie
Blue Silicone
Dome Gasket
ButtonControl Box Control Box
Nut
Nut
Refer to this illustration to familiarize
yourself with terms for parts of the
Dual Flush Converter
*This device is not intended to be used as a retrofit device for
1.28 gpf water closets. Performance may vary since product
was not tested on all models of water closets.
Match the color-coded hole to the corresponding Handle/Button connection
pieces, attach white Control Box to Handle/Button. Audible click assures that
Clip has secured Control Box to Handle/Button and unit will no longer pull
apart without pushing the Green or Blue Push Release.
CONTROL BOX AND CONTROL CABLE MUST NOT TOUCH FILL VALVE OR
INTERFERE WITH FILL VALVE'S OPERATION.
Install Refill Tube of fill valve. Attach Clip to overflow tube.Trim tubing to
size to prevent kinking and install tubing ontothe Mini-Valve Refill Tube Port.
15
16
For units with Handle, position and hand tighten Handle in a standard
operating position.
For units with Button, hand tighten Button with smaller Quick Flush
Button positioned above the Full Flush Button
13
14
Slide Base down overflow tube, seating Blue Silicone Gasket into flush
valve. Unit is designed to install vertically with both angled and straight
flush valve openings.
If gap appears around overflow tube, estimate width of space and use
with thick, medium or thin section of Cam, as needed to fill gap
11
12
Overflow
Tube
Flush Valve
Blue Silicone
Gasket
Cam
Thin
Medium
Thick
Fill Gap with Cam
A Slide Black Rubber Ring onto
overflow tube. Maintain slight
downward pressure to Rubber Ring.
B Then pull Zip Tie tight.
C Attach Upper Housing to Base
D Twist to lock in place.
Black Rubber
Ring
B
A
Zip Tie
C
D
Handle/Button
Handle
Position
Quick Flush
Button
Refill Tube Port Refill Tube
Clip to top
of overfill tube
Full Flush
Button
Handle/Button Assembly
Control Box
Control Cable
Upper
Housing
Fill Valve