Instructions / Assembly

Installing The Water-Saving Fast Fill Valve
These instructions provide the manufacturer's recommendation for installing the fill valve and the dual flush cpnverter together
so that the maximum water savings can be achieved. These instructions are designed to work in most toilets. Your toilet may
require additional adjustment to maximize water savings and optimize performance.
Thank you for purchasing this Total Repair Conversion Kit
This product helps the environment and your wallet by saving thousands of gallons (litres) of water every year!
Refer to this illustration to
familiarize yourself
with terms for the parts
of the Fill Valve.
Shut off water, flush toilet to empty tank and remove
old toilet fill valve.
Lay J-tube along back of bottom of tank, with Sliding Elbow in back
right-hand corner, as shown. Place Valve in tank to estimate J-tube length
needed. Before attaching J-tube, adjust length by pulling J-tube through
Sliding Elbow if needed. For small tanks, trim connecting end carefully to
fit. Push J-tube onto bottom port of valve.
BEFORE YOU BEGIN
Mark this level before shutting off
water or flushing toilet. This mark
will be referred to in the Water
Saving Tips and Tricks section.
Flexible tubing may need to be cut to fit all tanks
Tank
sizes
vary
Thumb Screw
Fill Valve Float
Upper Valve Body
Positive Locking
Mechanism
Smart Nut
®
Rubber Washer
J-Tube Nozzle
J-Tube (optional)
Refil Tube
Clip
Refill Tube Port
Mini-Valve
®
Float Lock
Sliding
Elbow
1
2
Adjust Valve height so that top of Cap is even with top of tank. This
height should allow the final Float adjustment to be achieved with
Thumb Screw (described later). Turn Upper Body counterclockwise
to lock in Valve height.
If overflow tube has a cap, remove it and discard before installing
Refill Tube. Proceed to installing the dual flush converter.
7
8
Cap
Upper
Body
Top Of Tank
Overflow
Tube
1˝ min
The C.L.
Line must
be at least
1˝ above
the top of
the overflow
tube.
Engage white Float Lock by sliding towards Cap.
To adjust Valve height with unit installed in tank, grasp upper portion,
placing thumb on gray side of Mini-Valve and push clockwise ¼ turn.
Slide Upper Body to adjust up or down.
5
6
Install Valve with Rubber Washer seated as shown above.
Nozzle should point back and right within tank.
The Smart Nut should only be hand tightened and should make 1-3
audible clicks to signal it is tight. Wings are designed to bend if if
Smart Nut is overtightened, preventing leaks and cracking.
3
4
Rubber
Washer
Smart Nut
Tank Bottom
Back of Tank
Nozzle
Wing Wing
Nozzle
Push Here
Float Lock