User Manual

WARNING:
Make sure the speaker is properly secured to the structure, and the
structure can handle the total weight suspended on it. Failure to do
so may cause damage or injuries.
HANDS-ON
3
NEXT Audiocom | P Series
SUSPENSION INSTRUCTIONS
Route the cables through the top cover.
In the P4, use the selector to choose your desired mode of
operation and power tap. Strip the wires about 3 to 4
millimeters from the tip and mount the supplied connector.
Insert the connector on the P4 and after fixing the buckle part,
fit the cover in the P4 and with the supplied eye bolt and nut.
Be sure to check that the eye bolt is properly and sufficiently
inserted as it is through it that the P4 is suspended.
Route the hanging cable through the eyebolt and using the
two supplied carabiners secure the P4 to the structure.
NOTE: For faster and easier installation use the available
Gripple accessories.
WALL MOUNT INSTRUCTIONS
Unscrew the nut + screw that holds the rotation ball. Remove
the ball from the bracket. Take care to not lose any small parts.
Use the wall mount to mark the spots for the holes. Secure the
wall mount to the wall with four screws. Apply the rotation
ball to the speaker by screwing it. Install the speaker +
rotation ball on the bracket and fix it with the screw + nut.
GARDEN MOUNT INSTRUCTIONS
Use the Garden Base Plate to install the P4 on rigid surfaces.
Follow the install instructions below.
You can also use the garden bracket on soft surfaces like
buried into the soil. Dig a hole with approximately 18.5cm
(7.25”) and insert the bracket into the soil.
18.5cm
7.25”
NOTE: The logo badge can be removed, from the grille, without damage.