User Manual

NEXT>>>ADVANCE www.nextadvance.com SP1000 series operator’s manual
Manual SP1000 series 49
DIS Query volume dispensed
CLD { INF | WDR } Clear volume dispensed
SAF [ <n> [ <n> [ <n> ] ] ] Safe communications mode
AL [ <on-off> ] Alarm mode
PF [ <on-off> ] Power failure mode
TRG [ FT | FH | F2 | LE | ST | T2 | SP | P2 | RL | RH | SL | SH ] Operational trigger default mode
DIN [ 0 | 1] Directional input control mode
ROM [0 | 1] Pump Motor Operating TTL output mode
LOC [ P ] [ <on-off> ] Keypad lockout mode or Program Entry Mode lockout
BP [ <on-off> ] Key beep mode
OUT 5 { 0 | 1 } Set TTL output level
IN { 2 | 3 | 4 | 6 } Query TTL input level
BUZ [ 0 | { 1 [ < n > ] } ] Buzzer control
VER Query firmware version
*ADR [ <n> [<n>] [ B <baud-rate>] ] Network address and baud rate (system command, valid
regardless of current address)
*ADR [ DUAL | RECP ] Set Reciprocating or Dual pumping mode
*RESET Clears program memory and resets communication
parameters (system command, valid regardless of current
address)
------------------------------------------------------------------------------------------------------------------------------
Network Command Burst => <n> <command> * [Network Command Burst]
- Communicate simultaneously with multiple pumps on a pump network.
Any command preceded by the asterik symbol ‘*’ bypasses the pump network address and Safe mode.
12.2 RS-232 Pump Network Connector Wiring
RS-232
To Network
To Computer
PC Com Port Connectors
25 Pin
9 Pin
3 - Receive 2 - Receive Connect to pump TXD
2 - Transmit 3 - Transmit Connect to pump RCV
9 - Ground 5 - Ground Connect to pump GND
RCV from network
TXD to network
TXD to computer
RCV from computer