Notification Manual

5
Advanced Menu
Note: These screens are only available with the notification units.
Lock\Unlock Configuration
Lock configuration to prevent accidental changes.
Unlock configuration to make changes.
Press ENTER when cursor is over desired position.
DHCP
'DHCP' stands for 'Dynamic Host Configuration Protocol'.
By default this is turned on and allows for the Network IP
Information to configure automatically. Recommended to
be enabled.
Press ENTER when cursor is over desired position.
Email Status
Set this for the interval to receive Status Emails. Each
number is the number of Self-Tests which occur every 12
hours. In the screen the Recurring amount is set to '02',
which will send a status email after every two Self-Tests
or every 24 hours.
Use the left and right arrows to adjust the number. The
number will increment from '0-28', Press ENTER to
select.
00 – Disables Status Email
Status Email Port:
Used to set port for sending Status Emails
Valid values are 25 and 587
Use the left, right arrows to change the number. Press
ENTER to select.
HTTP Port
Sets HTTP port valves: '80','81','82','83','84','00'. Defaults
to Port '80'. Use left, right arrows to select port. Range is
80-84,
00 – Disables HTTP
Press ENTER to select.
TFTP Update
TFTP Update turns on TFTP firmware or image updates
using the TFTP protocol. This should only be turned on to
update firmware or web image images and then turned off.
The HTTP update process is the preferred method to
update firmware or web images.
Press ENTER when cursor is over desired position.
Email Port? 025
HTTP Port ? 80
TFTP Update ? On Off
Lock Configuration
? On Off
DHCP ? On Off
E-Recurring ? 02