Quick Start Guide

P a g e | 7
2.1.2 Bracket Installation
The Starlight unit is mounted onto the Kegs using a permanently welded 1.7mm SS304 bracket.
Below are requirements for bracket installation which must be followed to enable the correct function of the
Starlight unit. If the bracket is not welded per below instructions, any warranty on the Starlight unit will be
void.
1) Bottom of Starlight unit casing is lightly touching the Keg dome surface for sufficient heat transfer
(tolerance is 0.0-0.5mm). This tolerance is critical to the correct thermal sensing operation of the device.
2) The Starlight unit should be level with the horizon with a +/-2 Degree tolerance. This tolerance is critical
to the correct motion engine operation of the device.