User's Manual

BewellConnect - BW-PX10 - 012015

This product complies with EN 301 489-7, -1; EN 300 440-1, -2 ; EN 301 511; EN 301 489-1, 3;

EN60950-1; SGS UK 0890; Reach (RoHS).

Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to

operate the equipment.

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC

Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the

equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

-- Reorient or relocate the receiving antenna.

-- Increase the separation between the equipment and receiver.

-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

-- Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not

cause harmful interference, and (2) this device must accept any interference received, including interference that may cause

undesired operation.

FCC RF Exposure Requirements:

This equipment must be installed and operated in accordance with provided instructions and the antenna(s) used for

this transmitter must be installed to provide a separation distance of at least 20

cm from all persons and must not be

co-located or operating in conjunction with any other antenna or transmitter. End-users and installers must be

provided with antenna installation instructions and transmitter operating conditions for satisfying RF exposure

compliance.

CAUTION: This device is designed for use on Domestic Animal ONLY