Instructions / Assembly

17
Operating instructions
LIGHTING THE APPLIANCE
1. Read instruction before lighting.
2. When you are sure there are no leaks, turn cylinder
valve and regulator control valve on hose to the
closed position.
3. Reopen cylinder valve fully.
4. Have a standard match, fireplace match or long-nosed
propane lighter lit and ready to place over the burner.
5. Light the burner from the burner top before opening
the gas supply, keeping hands and face away from
open burner.
6. Place lighter over the burner open, then slowly open
regulator valve until burner ignites.
7. Adjust the regulator control valve for desired flame height.
8. When finished using the cooker, turn off gas cylinder valve first. It will take a few second for the fire to go
out and for the propane gas to “bleed” from the hose and regulator assembly. After the fire is completely
out, turn regulator control valve to the “OFF” position.
9. To re-light, repeat steps 1 - 8. Always use CAUTION as cooker will be hot.
10. If ignition does not occur in 5 seconds, turn the burner control(s) off, wait 5 minutes, and repeat the
lighting procedure.
11. If the appliance fails to ignite after the second attempt, call our Customer Service Department at U.S.A:
1-800-913-8999.
Match
Counterclockwise to
open the gas supply
BURNER FLAME CHECK
Light Burner, rotate knob from HIGH to LOW. You should see a smaller flame in LOW position than seen on
HIGH. Always check flame prior to each use.
TURNING LP COOKER OFF
Turn all knobs to OFF position, turn LP tank OFF by turning hand-wheel clockwise to a full stop.
HOSE ASSEMBLY AND REGULATOR CHECK
Cleaning and inspection of pressure regulator and hose assembly prior to use. If there is evidence of abrasion,
wear, cuts or leaks, the hose assembly must be replaced prior to the appliance being put into operation. The
replacement hose assembly shall be that specified by the manufacturer.
WARNING
Keep head, body, and hands away from the top of the burner while lighting to avoid injury due to fire.