Instructions

Fig.D

Fig.B
Fig.F
Fig.A
Fig.E
  
Fig.C
ASSEMBLY INSTRUCTIONS
1 Select an appropriate location to secure
the detector on the ceiling or wall
 The attachment surface must be smooth
and at. Compatible surfaces for the adhesive:
paint, metal, plastic, glass and smooth, non-
porous wood
 Locations exposed to direct sunlight (e.g. the
glass roof of a greenhouse) are not compatible
with this adhesive
 Check that ambient temperature is between
16°C and 35 °C
 If in doubt, secure the detector with
the screws and anchors provided
2 Clean the attachment surfaces (attachment
base and wall / ceiling)
 The attachment surface must be dry and
free of dust, grease or other impurities: all
damaged coatings (paint, etc.) must be
removed
 Only use clean cloths and non-greasy alco-
hol-based grease removers: check that the
surfaces are dry before applying the adhesive
3 Take the smoke detector o its base
4 Remove the red protection lm from the
adhesive (g.A)
 Check that the adhesive is in good condi-
tion: the red and white protection lms are
in position and no dust or other pollutants
are present on either side of the adhesive
 Avoid placing your ngers on the self-
adhesive part
5 Ax the adhesive to the attachment base
(g.B)
 Apply even pressure over the adhesive
surface for 10 seconds and then wait for 15
minutes (g.C)
6 Ax the attachment base to the wall or
ceiling after cleaning these surfaces.
Check the preferred direction of the detec-
tor before xing the attachment disk to the
ceiling/wall.
 Remove the white protection lm from
the adhesive (g.D)
 Avoid placing your ngers on the self-
adhesive part
 Ax the attachment base to the wall or
ceiling without the smoke detector (g.E)
 Hold the attachment base rmly against
the wall or ceiling by pressing hard with
your thumb for 10 seconds (g.F)
Notice D177B_EN.indd 1 11/03/2016 18:24