User's Manual

Chapter 3: System Setup
Installing a SATA Hard Drive
1. The metal bracket is used to hold a SATA hard drive. First, remove the
screws that secure the metal bracket to the board then remove the
bracket.
Metal
bracket
· During Windows XP OS installation, press “F6” to select and
install the SATA driver.
· If you intend to install a Windows XP SP2 or earlier version, you
must first set the “USB 2.0 Controller” field (in the BIOS) to
Disabled.
· By default, the “Legacy USB Support” field (in the BIOS) is
Disabled. If you are using a USB device to install the Windows
operating system, you must first set this field to Enabled. Set this
field back to Disabled after you have finished the installation.
2. Position the HDD brackets on each side of the SATA drive. Align the
mounting holes that are on the sides of the SATA drive with the HDD
brackets’ mounting screws.
Mounting
screws
HDD bracket
If you intend to install a CompactFlash card or a Mini PCI Express
module, please install these devices first before proceeding to the
next step. Refer to their respective sections in this chapter for in-
structions on installing a CF card or a Mini PCI Express module.
Copyright © 2009 NEXCOM International Co., Ltd. All Rights Reserved.
51
SATA drive
Mounting
screws
VTC 6110 User Manual