User's Manual
LAERDAL MEDICAL AS Link Box – Quick-Setup-Guide 7 / 7
FCC STATEMENT
This device complies with part 15 of the FCC rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) This device must accept any interference received, including interference that may cause
undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment
off and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Consult the dealer or an experienced radio/TV technician for help.
The use of shielded I/O cables is required when connecting this equipment to any and all optional
peripheral or host devices. Failure to do so may violate FCC rules.
IMPORTANT Changes or modifications not covered in this manual must be approved in writing
by the manufacturer’s Regulatory Engineering Department. Changes or modifications made
without written approval may void the user’s authority to operate this equipment.
CANADIAN ICES-003 STATEMENT
This Class B digital apparatus meets all of the requirements of the Canadian Interference-Causing
Equipment Regulations.
Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel
brouilleur du Canada.
CE COMPLIANCE STATEMENT
This product was tested and found to comply with all the requirements of the EMC Directive
2004/108/EC as amended.