User's Manual

Preface

This manual is for WLAN service providers or network administrators to set up a network environment

using the IWF series Product line. It contains step-by-step procedures and graphic examples to guide MIS

staff or individuals with slight network system knowledge to complete the installation.

This publication, including all photographs, illustrations and software, is protected under international

transmitted in any form or by any means without the prior written consent from NEXCOM International Co.,

Ltd.

Disclaimer

The information in this document is subject to change without prior notice and does not represent

commitment from NEXCOM International Co., Ltd. However, users may update their knowledge of any

product in use by constantly checking its manual posted on our website: http://www.nexcom.com.

NEXCOM shall not be liable for direct, indirect, special, incidental, or consequential damages arising out of

the use of any product, nor for any infringements upon the rights of third parties, which may result from such

use. Any implied warranties of merchantability or fitness for any particular purpose is also disclaimed.

Acknowledgements

IWF series are trademarks of NEXCOM International Co., Ltd. All other product names mentioned herein

are registered trademarks of their respective owners.

Regulatory Compliance Statements

This section provides the FCC compliance statement for Class B devices and describes how to keep the

system CE compliant.

Declaration of Conformity

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses and can radiate radio frequency

energy and, if not installed and used in accordance with the instructions, may cause harmful interference to

radio communications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the interference by