User's Manual

User’s Manual
Light Industrial AP ENGLISH
17
Copyright © NEXCOM, INC.
NTP Setup
Step 2: Configuring the AP’s Network Settings
While still on this Page, click on the Network Interface tab to begin configuration of the network
settings.
Network Settings Page
If the deployment decides that the AP will be getting dynamic IP Addresses from the connected
network, set Mode to DHCP; otherwise, set Mode to Static and fill in the required fields marked with
a red asterisk (IP Address, Netmask, Gateway, and Primary DNS Server) with the appropriate
values for the network. Click SAVE when you are finished to save changes that have been made.
Step 3: Configure the AP’s Wireless General Settings
Click on the Wireless icon followed by the General tab. On this page we need to choose the Band
and Channel that we wish to use.