User's Manual
Table Of Contents
- Preface
- Copyright
- Disclaimer
- Acknowledgements
- Regulatory Compliance Statements
- Declaration of Conformity
- RoHS Compliance
- Warranty and RMA
- Safety Information
- Installation Recommendations
- Safety Precautions
- Technical Support and Assistance
- Conventions Used in this Manual
- Global Service Contact Information
- Package Contents
- Ordering Information
- Chapter 1: Product Introduction
- Chapter 2: Jumpers and Connectors
- Chapter 3: System Setup
- Chapter 4: Android OS Menu Introduction
- Appendix A: Regulatory Statements
Copyright © 2016 NEXCOM International Co., Ltd. All Rights Reserved.
11
NDiS B115 User Manual
Chapter 3: System Setup
Installing the Hardware
1. To start using NDiS B115, you need the following:
– A high-definition TV (HDTV) or LCD with HDMI port.
– Ethernet network or 802.11b/g/n Wi-Fi wireless AP.
2. Hardware Installation:
– Connect an HDMI TV to the HDMI port with an HDMI extension cable.
– Connect a USB mouse to the USB port.
– Connect the Ethernet port to the ADSL modem or router with a RJ45
cable. (If you use Wi-Fi, please ignore this step.)
– Plug in the power adapter to the DC IN, then connect the adapter
to a wall socket. After the Device boots up, you will see the main
page of NDiS B115. (If you use an HDMI TV, please use the TV remote
controller to select the HDMI interface.)
Step 1
Step 4
Step 3
Step 2