Use and Care Manual

36" Hybrid Composite Railing Installation Guide / v20210527US 14
7
The bottom rail bracket (H) should be
installed with screw (R) at 1 3/16" (29.5 mm)
and 15/16" (24 mm) from the ends of the rail
as shown in Diagram 28. Alternatively, a at
board can be used to press the bracket up
against the end of rail to line up the correct
distance.
DIAGRAM 28
DIAGRAM 29
Screw (R)
Screw (R)
1 3/16"
(29.5 mm)
1 3/16"
(29.5 mm)
15/16"
(24 mm)
15/16"
(24 mm)
A1
DIAGRAM 30
6
Cut rail (A1 & A2) to the length between the
post sleeve (N) minus 1/8" (3 mm) on each
side for inserting the rail gaskets (F) as
shown in Diagram 26.
Remember to take out top rail insert (B)
before cutting top rail (A1). The top rail
insert (B) should be cut 1/4" (6 mm) shorter
than the top rail (A1).
Note: Need to leave a minimum 3 1/16"
(78 mm) or a maximum 3 3/8" (85 mm)
between the ends of the rail and the rst
hole of each end as shown in Diagram 27.
8
Pre-drill and install the foot blocks (I) with
screw (R) on the bottom rail as shown in
Diagram 29. Foot blocks should be evenly
spaced out depending on the length
of the final rail and cannot be installed
underneath a pre-drilled baluster hole.
Note: Top rail is A1 in Diagram 30. The holes
should be facing downwards. Bottom rail
is A2 in Diagram 30. The holes should be
facing upwards.
DIAGRAM 27
DIAGRAM 26
Top Rail (A1)
3 1/16" (78 mm) ≤ L ≤ 3 3/8" (85 mm)
Boom Rail (A2)
3 1/16" (78 mm) ≤ L ≤ 3 3/8" (85 mm)
A2