Instructions / Assembly

36" Hybrid Composite Railing Installation Guide / v20170720 13
D-R0203 with
screw WJ0130
G-R0205 with
screw WJ0131
5
Pre-drill post bracket holes with a 3 mm
(7/64 inch) bit as shown in diagram 7.
Lower the post skirt (K-LV-0119) over the post
sleeve (N-UH35) as shown in diagram 8.
7
Cut rails (A-UR02) to the length (L1 in
diagram 11) between the post sleeve (N-
UH35) minus 3 mm (0.118") on each side for
inserting gaskets at a 32 degree angle. L1
can be measured like L minus 3 mm (0.118")
on each side.
Remember to take out galvanized insert (B-
LV-0209) before cutting rail (A-UR02). The
galvanized insert (B-LV-0209) should be cut
6 mm shorter than the rail (A-UR02).
6
Drill in the top post brackets (D-R0203)
with screw WJ0130 as shown in diagram 9.
Drill in the bottom post brackets (G-R0205)
with screw WJ0131 as shown in diagram 10.
DIAGRAM 7 DIAGRAM 8
DIAGRAM 9 DIAGRAM 10
DIAGRAM 11
DIAGRAM 6
914 mm
(36")
155 mm
(6.102")
Stairs -
Top Post
Stairs -
Bottom Post