Installation Guide

36" Hybrid Composite Railing Installation Guide / v20181120 10
DIAGRAM 23
7
Cut rail (A-UR02) to the length between the
post sleeve (N-UH35) minus 3 mm (0.118")
on each side for inserting the gaskets (F-
R0102) as shown in diagram 22.
Remember to take out galvanized insert (B-
R0224-1) before cutting rail (A-UR02). The
galvanized insert (B-R0224-1) should be cut
6mm shorter than the rail (A-UR02).
Note: Need to leave at least 75 mm (2.953")
between the ends of the rail and the first
hole of each end as shown in diagram 23.
DIAGRAM 22
G-R0205 with
P-WJ0131
6
Lower the post skirt (K-LV-0119) over the
post sleeve (N-UH35) as shown in diagram 19.
Drill in the top post brackets (D-R0223) with
screw (O-WJ0130) as shown in diagram 20.
Drill in the bottom post brackets (G-R0205)
with screw (P-WJ0131) as shown in diagram 21.
DIAGRAM 19 DIAGRAM 20
DIAGRAM 21
D-R0223 with
O-WJ0130