Installation Guide
36" Hybrid Composite Railing Installation Guide / v20181120 20
The galvanized insert (B-R0224-1) is designed
for a maximum of 1825.7 mm (71.9") as shown in
diagram 24.
The railing is designed for a maximum of 1857.5
mm (73.1") as in diagram 25.
9
The bottom bracket (H-R0204) should be
installed with screw (S-WJ0149) at 32.5
mm (1.28") and 24 mm (1") from the end of
the rail which will be placed on the higher
side of the stairs as shown in digram 26.
The bottom bracket (H-R0204) should be
installed with screw (S-WJ0149) at 28 mm
(1.1") and 24 mm (1") from the end of the rail
which will be placed on the lower side of
the stairs. Alternatively, a at board can be
used to press the bracket up against the
end of rail to line up the correct distance.
DIAGRAM 24
DIAGRAM 25
DIAGRAM 23
Note: Need to leave at least 83 mm (3.3")
between the ends of the rail and the rst hole of
each end as shown in diagram 23.
10
Pre-drill and install the foot blocks (I-R0217)
with screw (S-WJ0149) on the bottom rail
as shown in diagram 27. Foot blocks should
be evenly spaced out depending on the
length of the nal rail and cannot be installed
underneath a pre-drilled baluster hole.
Note: Top rail is A in diagram 28. The holes
should be facing downwards. Boom rail is
B in diagram 28. The holes should be facing
upwards.
S-WJ0149
A
B
S-WJ0149
DIAGRAM 26
DIAGRAM 28
DIAGRAM 27
11
Attach the galvanized adaptors (C-R0224-
2) on both ends of the galvanized insert (B-
R0224-1) as shown in diagram 29.