Instructions / Assembly

IMPORTANT: Read all sections before you start
For the most up to date information please visit our website @ www.newtechwood.com
Prior to installing any composite decking it is
recommended that you check with local building
codes for any special requirements or restrictions. The
diagrams and instructions outlined in this guide are for
illustration purposes only and are not meant or
implied to replace a licensed professional. Any
construction or use of NewTechWood must be in
accordance with all local zoning and/or building
codes. The consumer assumes all risks and liability
associated with the construction and use of this
product.
Safety
When dealing with any type of construction project it is
necessary to wear appropriate safety equipment to
avoid any risk of injuries. NewTechWood recommends
but is not limited to the following safety equipment
when handling, cutting, and installing NewTechWood:
gloves, a respiratory protection, long sleeves, pants,
and safety glasses.
Tools
Standard woodworking tools may be used. It is
recommended that all blades have a carbide tip.
Standard stainless steel or acceptable coated deck
screws and nails are recommended.
Environment
A clean, smooth, flat, and strong surface is needed to
install NewTechWood’s products correctly. Please
check with local building codes before ever installing
any type of decking. If installation does not occur
immediately NewTechWood’s products need to be put
on a flat surface at all times. Never ever should it be put
on a surface that isn’t flat.
Planning
Plan a layout for your decking before starting it to
ensure the best possible looking decking for your
project. Building codes and zoning ordinances generally
apply to permanent structures, meaning anything that is
anchored to the ground or attached to the house. So
nearly every kind of decking requires permits and
inspections from a local building department. We
recommend drawing out a site plan of your proposed
project that you intend to do to minimize errors and
make your perfect decking.
Construction
NewTechWood UltraShield is NOT intended for use
as columns, support posts, beams, joist stringers or
other primary load-bearing members. NewTechWood
must be supported by a code-compliant
substructure. While NewTechWood products are
great for retrofits NewTechWood’s products CANNOT
be installed on existing decking boards.
Static
Static build-up is a natural occurring phenomenon
that can occur with many plastic products. Dry and
windy environments may make this even more
apparent, this all varies depending on the climate and
age of the decking.
Ventilation
NewTechWood products CANNOT be directly installed
onto a flat surface. It must be installed onto a
substructure, so there is adequate and unobstructed air
flow under the decking to prevent excessive water
absorption. A minimum of 4 inches of continuous net
free area under the decking surface is required for
adequate ventilation on all decking so air can circulate
between adjacent members to promote drainage and
drying.
v20151224