Safety data sheet

—Material Safety Data Sheet—

υ Datas and dimensions are just reference values.For further details,please

υ Contents are subject to change without notice.

Document Number: MSDS-SWT - CR / 05E1

Revisedl：

2006-12 Page 6 of 13

Newsun

B. Under condition where normal current flow through the battery will increase , the

battery should not be connected in series with the power supply.

C. When connecting a lead wire to the battery . direct soldering or direct spot welding to the

battery should be avoided.

D. In the case of soldering , practice it at the following condition ; temperature of solder ;

270 and less , soldering time : 5 sec . and less.℃

E. In the case of automated soldering , dip only the battery terminal in solder bath and be sure

that the battery is not stopped , nor fallen in the bath.

F. When the battery is used in apparatus which heats , set the battery away from the heating

part or if the battery is near the heat source , isolate them and design the insertion so that

the temperature at the battery is 60 and less. ℃

2.Prohibitive matters when handing Coin type Manganese Dioxide Lithium batteries

¬ The voltage of Coin type Manganese Dioxide Lithium batteries(3.0V) is different from

the voltage of the following batteries, so use Coin type Manganese Dioxide Lithium

batteries only in apparatus specially designed for them.

¬ Conventional batteries with different voltage: Manganese dry batteries(1.5V), Alkaline

manganese button batteries(1.5V);Sliveroxide batteries(1.5V),Mercury batteries

(1.4V),Lithium/Thionyl Chloride batteries(3.6V),etc.

¬ Do not use different types of batteries together, nor mix partially used batteries with new

ones.

¬ Do not use short-circuit （+）（-） of batteries.

¬ Do not reversely connect（+）（-） of batteries.