RS Quick-Start-Guide

The internal PC does not support hot plugging. Therefore, you must insert or remove the

internal PC when the display is powered off. Otherwise, the display or internal PC may be

damaged.

You will need to purchase the internal PC separately. Perform the following steps to install the

internal PC.

Step 1 Unscrew the M3 screws by hand to remove the internal PC shielding cover.

Step 2 Push the internal PC into the internal PC port at the rear of the panel from right to left.

Step 3 Secure the internal PC to the display by using the M3 screws.

Step 4 Ensure the installation is correct before turning the power on again.