User's Guide
Installation
V
The sensor should be mounted in the upright position with cable exit on the sensor pointing downwards.
Select the appropriate location to mount the sensor.
a. Height tolerance (from ground); 1m +/- 0.3 m)
b. Vertical angle tolerance +5 (up), -2° (down)
c. Horizontal angle tolerance +/- 5
Note:
Before permanently installing the RODS(Radar object detection sensor) on the vehicle, verify that the
selected sensor mounting location provides a clear detection zone.
Take the machine to a clear area, temporarily attach the sensor in the proposed mounting location,
apply power to the system, and verify that nothing is being detected.
Our system is not affected if multiple systems are operating in the same area or on the same vehicle,
even if they are installed in close proximity with overlap
ping detection ranges.
-5°
+5°
-2° +5°
The installation site should be flat. Ideally the radar sensor should be mounted
on the rear of the
vehicles as close to the center as possible at roughly 1 meter above the ground.
◈ Sensor Mounting
◈ Mounting angle
4
Display Unit install
Display Unit
HSH SEM'S M3*8 SUS X 4 ea
TAPPING SCREW TH
T1 Ø3*10 SUS X 2 ea
SPRING WASHER Ø3 SUS X 2 ea
Bracket
Radar Sensor install
Radar Sensor
SPRING WASHER
Ø5 SUS X 4 ea
TAPPING SCREW PWH
T1 Ø5*15 SUS X 4 ea
Bracket
HSH SEM'S M5*12
SUS X 4 ea