User guide

Chapter 3 - AssemblyNewer Technology Guardian MAXimus mini
To remove the drives, turn the Newer
Technology Guardian MAXimus mini
around to the rear and remove the hard
drive cover plate by unscrewing the 2
Phillips screws from the top corners.
Once you have removed the back of the
Newer Technology Guardian MAXimus
mini, the two 2.5” hard drives are held
into the chassis using friction t trays. To
remove the two drives and their trays, you
need to pull the trays out of the back of
the enclosure using the silver metal tabs
in the center of the drive tray. To keep
vibration to a minumum, the silver trays
are a very tight t. Use constant, gentle
pressure when removing and installing.
Turn the drive tray over and you will see 2
Phillips screws that are holding the drive
into the tray. Remove those two Phillips
screws. Then. Slide the hard drive out of
the drive tray, pushing the drive out of
the tray.
Replace the drive in the reverse order,
insert the screws and then place the drive
tray assembly back into the enclosure.
Replace the back access cover and rein-
sert the 2 Phillips screws you removed to
take the back cover o.