Operation Manual

ManualsBrandsNewcon ManualsAirgun AccessoriesSTARGATE M. 2x35 Night Vision Monocular

NEWCON INC. 2001 Printed in Canada

OPERATION MANUAL

NIGHT VISION MONOCULAR

STARGATE M

In USA: 3310 Prospect Ave. Cleveland, OH 44115

In Canada: 1183 Finch Ave. W., Suite 302, Toronto, ON. M3J 2G2 Canada

Tel: (416) 663-6963 Fax: (416) 663-9065

Email: NEWCONSALES@NEWCON-OPTIK.COM

Internet: www.newcon-optik.com

Summary of content (6 pages)

PAGE 1
OPERATION MANUAL NIGHT VISION MONOCULAR NEWCON INC. 2001 Printed in Canada STARGATE M In USA: 3310 Prospect Ave. Cleveland, OH 44115 In Canada: 1183 Finch Ave. W., Suite 302, Toronto, ON. M3J 2G2 Canada Tel: (416) 663-6963 Fax: (416) 663-9065 Email: NEWCONSALES@NEWCON-OPTIK.COM Internet: www.newcon-optik.
PAGE 2
IMPORTANT INFORMATION ATTENTION! Read prior to activation You have just purchased a complicated electronic device. To operate it properly, please read this manual carefully. Here are some common precautions that must be noted. NEVER expose the opened objective lens of an active unit in daylight. (Note: 1st generation units will still remain active for a few minutes after switching the unit off). At daytime objective lens must be covered by caps.
PAGE 3
10. ACCEPTANCE CERTIFICATE NIGHT VISION DEVICE STARGATE M Serial Number _______________________________ Model Stargate M corresponds to technical conditions ADSH 3.807.020 TU and is admitted for use. Date of production __________________ Place for seal Quality inspector ____________________ (Signature) For best performance, keep the device in a dry place when not in use. Long-term exposure to high humidity environment will cause irrecoverable damage to the activation mechanism.
PAGE 4
CONTENTS a. Warnings b. Precautions 1. Overview i. Application and Advantages of STARGATE- M ii. Features 1. Specifications 2. Construction 3. Operating Instructions 4. Care and Maintenance 5. Troubleshooting 6. Warranty 7. Customer support 8. Acceptance Certificate THANK YOU FOR PURCHASING STARGATE M NIGHT VISION DEVICE. PLEASE DEMAND TO CHECK THE DEVICE FOR PROPER OPERATION WHEN BUYING IT. PLEASE READ ALL THE INSTRUCTIONS CAREFULLY BEFORE USING. 1.
PAGE 5
Condensation accumulates on the parts. Features: • One stage image intensifier tube with Multi alkaline photocathode and image It is O.K. to use the scope in cold. However, when the unit is brought from the cold into a warm environment, it has to warm up for up to 5 hours (not minutes!). Only then it is allowed to turn it ON again. • Visibility decreases and / or disappears. • Bright light sources (moon, projectors or headlights) may cause visibility to degrade or even completely disappear.
PAGE 6
4.CONSTRUCTION Proper operation of the activation lever: Push it down and hold in this position. This should provide 30-60 seconds of operation (or more). Once the screen begins to get dimmer boost the image by releasing the handle and pushing it down again after a few seconds (not immediately!). Pumping the lever up and down rapidly is wrong! That will deactivate the power mechanism. You will need to wait 15-30 minutes before activating it again.