Operation Manual

11. ACCEPTANCE CERTIFICATE
NIGHT VISION DEVICE
Serial Number _______________________________
Model _NZT-1M2_____________________________
corresponds to technical conditions ADSH 3.807.020 TU and is
admitted for use.
Date of production -____________________
Place for seal
Quality inspector ____________________
(signature)
18
• NEVER disassemble the unit. This device
contains high voltage, which may be hazardous
to your health!
•
NEVER expose the opened objective lens of an active
unit in daylight. (Note: 1st generation units will still remain
active for a few minutes after switching the unit off). At
daytime objective lens must be covered by caps. There is a
tiny hole in the cap to provide enough light for daytime
operation. It is allowed to turn on the unit at daytime, but
caps must cover the lenses.
•
NEVER aim active unit at intense light sources
(i.e. lights, headlamps, campfires, the moon,
etc.)
•
NEVER reverse the polarity of a battery
•
NEVER connect the unit to external power
sources
•
ALWAYS remove batteries when not in use for
a long period
3