User Manual

PAGE 4
COFFEE PREPARATION PROCEDURES
1. Place filter into brew basket.
2. Put the proper amount of coffee into the filter.
3. Slide the brew basket into holder.
4. Place the appropriate empty decanter into position below the brew basket. For airpots first open lid and remove
pump stem. For other dispensers remove the lid unless it is a brew thru design. Turn lower warmer switch, or
power switch for dispenser brewers, to the ON position.
5. Press brew start switch. (Brew cycle may be canceled by turning the rocker switch back to the OFF position.)
6. Hot water will be delivered through the sprayhead. This distributes the hot water evenly over the coffee bed
within the brew basket. The coffee brew will drain from the brew basket into the decanter below.
7. The resultant coffee brew should be crystal clear and have the desired properties attainable through excellent
extraction.
8. Turn off the warmer and power switches as applicable when not in use. Red light in switch indicates when
power is on. Note: The solenoid will not run to replace water in tank that is drawn off from the faucet when the
lower warmer switch, or power switch for dispenser models, is in the OFF position. However when the brew
cycle is again initiated the tank will fill before cycle begins to prevent a short pot.
9. To clean brew basket simply remove from brew rails and dump filter into waste basket. The brewing process,
as described above, can now be started again.
LIMING: To prevent liming problems in tank, sprayhead tubes, and vacuum breakers fittings remove sprayhead and
insert deliming spring all the way into the tank. When inserted into tank properly, no more than ten inches of the spring
should be visible at the sprayhead fitting. Saw back and forth five or six times. T his will keep fittings open and clear of
lime. In hard water areas this should be done everyday. This process takes approximately one minute. In all areas the
sprayhead should be cleaned at least once a week. Where bad liming has already occurred, a new complete tank
assembly may be installed.
WARRANTY
Newco coffee brewers are warranted against defects in workmanship or materials, under normal use, for one
year from the date of purchase.
Liability in all events is limited to the purchase price paid and liability under the aforesaid warranty is limited to
replacing or repairing any part or parts which are defective in material or workmanship, and returned to our factory,
shipping cost prepaid. No warranty expressed or implied, other than the aforesaid is made or authorized by Newco
Enterprises, Inc.
Prompt disposition will be made if item proves to be defective, within warranty. Before returning any item, write
or call Newco, or the dealer from whom the product was purchased, giving model number, serial number, and date of
purchase, and describe nature of the defect. If damage was incurred during transit to you, file claim with the carrier.