Instructions / Assembly

8
http://www.NewAir.com
5. Turn on the Red (hot) tap until water flows from it.
6. Plug the unit into an appropriate wall outlet.
7. Turn on the switches on the rear of the unit one at a time (do not turn on
the switches at the same time). The heating lamp and the cooling lamp will
light up.
INITIAL CLEANING
This unit has been cleaned and sanitized prior to shipping. However, to remove
dust accumulated during shipping, we recommend rinsing the water lines and
tank upon initial operation:
1. Allow the unit to run with the water bottle in place for 30 minutes.
2. After 30 minutes, turn the unit off, unplug it, and remove the water bottle.
3. Run all taps until they are empty, then open the drain plug on the back of
the unit and drain remaining water from the dispenser into a bucket or
other container.
4. Once the unit has been completely flushed, you can replace the bottle and
restart the unit according to the instructions above.
CAUTION: To avoid burns, avoid direct contact with the hot water.
Never allow children to dispense hot water without supervision.
CLEANING & MAINTENANCE
Unplug the unit from the electric outlet before performing any maintenance or
servicing the product.
CLEANING THE HOUSING
 Use a soft, damp cloth to wipe the body clean. Clean the drip tray and
storage cabinet as needed.
 Remove dust from the condenser coils on the back of the unit to improve
efficiency.
 Never use strong chemicals, gasoline, detergents, chemically-treated
cloths, or any other cleaning solutions to clean the water dispenser, as
these can all potentially damage the unit.
 Never use detergent or chemicals harmful to health when cleaning.