Instructions / Assembly

7
A Name You Can Trust
 The unit must be placed within reach of a properly-rated grounded socket.
 Never place any obstacles around the air inlet or outlet of the unit.
 Allow a minimum 6-inch clearance on all sides for efficient operation.
OPERATION
To dispense hot water, pull the lever on the spigot upwards before pulling both
the lever and the spigot downwards.
IMPORTANT: Customers are not meant to adjust the
temperature by themselves by removing the sticker or screw at
the back of the appliance. Doing so will void the warranty if
product issues are found to be caused by such adjustments.
TEMPERATURE ADJUSTMENT
To adjust the water temperature on the unit, locate the white plug on the left
side of the unit. Remove the plug to expose an area where you can use a flat tip
to adjust the water temperature for both hot and cold.
Do not adjust the temperature by manipulating the screw at the back of the
appliance because the unit may not cool or may not stop cooling. This can
form ice and damage the unit.
INITIAL SETUP
IMPORTANT: Do not plug in the unit before installing a water
bottle. Operating the unit with an empty hot water tank can
cause physical damage to the water dispenser.
WATER BOTTLE INSTALLATION
This unit is designed to work with 2-gallon, 3-gallon or 5-gallon bottles of
drinking water. To install the water bottle:
1. Remove the label from the cap of the bottle.
2. Use a clean cloth to wipe the cap and neck of the bottle.
3. Lift and invert the bottle, and insert the bottle neck into the water guard.
4. Allow bottle to fill the internal tank and wait for bubbles to stop rising from
the bottom of the bottle.