Instructions / Assembly

7
A Name You Can Trust
FACTORY ODOR REMOVAL
Wash the interior of the cooler with a mild detergent and warm water. Leave
the door open and allow it to air dry thoroughly. If a “plastic” smell persists,
place a dish of baking soda in the unit or stuff the cooler with newspapers
overnight. When finished, let the unit run a full day to complete the airing out
process.
DRAWER SET-UP
The drawers and shelves included with this cooler are designed to sit flush with
the front edge of the cabinet. This will allow air to circulate freely through the
unit. When inserting the drawers and shelves, avoid pushing them all the way
against the rear wall of the cabinet.
OPERATING INSTRUCTIONS
OPERATING ENVIRONMENT
It is recommended that the cooler be installed in an area where the ambient
temperature is between 50°- 80°F (10°-26°C). If the ambient temperature is
above or below the recommended ranges, the unit’s performance may be
affected, and extreme cold or hot conditions may cause the interior
temperature to fluctuate. This will prevent the optimal range of 65° - 73°F (18°
- 22°C) from being reached. In addition, keep in mind that the temperature may
fluctuate depending on whether the interior light is on or off, and how full the
cooler is.
HOW TO USE THE BUTTONS ON THE DI SPLAY PANEL