CC-121E Thermoelectric Cigar Cooler OWNERS MANUAL Read and save these instructions.
A Name You Can Trust Trust has to be earned and we will earn yours. Customer happiness is the focus of our business. From the factory to the warehouse, from the sales floor to your home, the whole NewAir family promises to provide you with innovative products, exceptional service, and support when you need it the most. Count on NewAir. As a proud NewAir owner, welcome to our family. There are no robots here, real people shipped your product and real people are here to help you.
READ AND SAVE THESE INSTRUCTIONS. TABLE OF CONTENTS Safety Information & Warnings ........................................................................... 4 Parts List ............................................................................................................... 5 Parts Diagram............................................................................................... 5 Assembly & Installation .......................................................................................
SAFETY INFORMATION & WARNINGS When using any electrical appliance, basic safety precautions must be followed in order to reduce the risk of fire, electrical shock and/or injury to persons or property. Be sure to read all instructions before using this appliance and observe the following safety tips: Attention: To prevent the risk of child entrapment, do not allow children to operate, play with, or crawl inside the unit.
PARTS LIST When you receive your unit, carefully remove the exterior and interior packaging. It is recommended that you retain the packaging for future use. Check to make sure the following parts are included: 1 slide-out shelf 2 drawers Door handle and 2 screws 1 instruction manual 1 removable wine rack A removable wine rack is included with the product, perfect for storing a few bottles of red wine with your cigars! PARTS DIAGRAM 1. 2. 3. 4. 5. Door hinge Light Shelf Drawer Foot 6. 7.
ASSEMBLY & INSTALLATION HANDLE ASSEMBLY Tools Required for Assembly: Phillips screwdriver (not included) Estimated Assembly Time: 5 minutes Before installation, attach the handle to the front of the unit with the included screws. It may be necessary to push aside the rubber seal on the inside of the door to reveal the screw holes. Caution: Avoid over-tightening the screws, or you may cause damage to the unit.
FACTORY ODOR REMOVAL Wash the interior of the cooler with a mild detergent and warm water. Leave the door open and allow it to air dry thoroughly. If a “plastic” smell persists, place a dish of baking soda in the unit or stuff the cooler with newspapers overnight. When finished, let the unit run a full day to complete the airing out process. DRAWER SET-UP The drawers and shelves included with this cooler are designed to sit flush with the front edge of the cabinet.
BUTTON FUNCTIONS: Raise the desired temperatures.* Lower the desired temperature. * Turn the light on and off. * The interior temperature can be adjusted in increments of 1 degree between 54° and 66°F (12° - 18°C). To change the temperature readout to either Fahrenheit or Celsius, simultaneously press and hold the UP and DOWN buttons for at least 3 seconds.
Turn the leveling feet up to the base in order to avoid damage. Tape the door shut. Be sure the cooler stays in an upright position during transportation. CIGAR STORAGE GUIDE The ideal temperature for storing cigars is between 65° and 73°F. The ideal relative humidity (RH) for storing cigars is between 65% and 75% RH. To properly monitor and maintain RH in the CC-121E, you will need to add a hygrometer (humidity gauge) and some variety of humidifier to the cooler.
TROUBLESHOOTIN Problem The cooler will not operate. The cooler is not cold enough. Possible Causes The unit may be plugged in using a different voltage. The circuit breaker may be tripped or there is a blown fuse. The external environment may require a higher setting. The door may be opened too frequently. The door is not closed completely. The door seal does not seal properly. The cooler does not have sufficient clearance. The light does not work. The cooler vibrates while operating.
Problem The door will not close properly. Possible Causes The unit is not leveled. Solution See above. The door is not properly installed. Check the door hinges to make sure they are properly installed. Replace the seal on the door. Replacements can be acquired from the manufacturer. Make sure the shelves slide all the way into the unit. Contact the manufacturer. The seal is weak. The shelves are out of position. The LED display does not work.
LIMITED MANUFACTURER’S WARRANTY This appliance is covered by a limited manufacturer’s warranty. For one year from the original date of purchase, the manufacturer will repair or replace any parts of this appliance that prove to be defective in materials and workmanship, provided the appliance has been used under normal operating conditions as intended by the manufacturer.
