Use and Care Manual

6
h p://www.NewA ir.com
ELECTRICAL CIRCUIT D IAGRAM
INSTALLATION
Before connec
the appliance to a power source, let it stand
upright for approximately 2 hours. This will reduce the possibility
of a malfun
on in the cooling system from handling during
transporta
on.
Before opera
ng your wine cooler for the first me, follow these steps:
Remove the exterior and interior packing.
Clean the interior surface of the unit with lukewarm water and a so
cloth.
Place the cooler on a level surface that will be strong enough to support the
unit when it is fully loaded. To level your cooler, adjust the front feet located
at the bottom of the unit.
θ
θ
θ θ
M MM MMM
CONTROL PCB
DISPLAY PCB
COMPRESSORPTC HEATER
TRANSFORMER
PLUG
SERNSOR1
SERNSOR2 LIGHT
FAN1
FAN2 FAN3 FAN4