Use and Care Guide

DRAINING THE UNIT
During the cooling process, some water will be extracted from the air and stored within the unit’s
water reservoir.
If the reservoir is full, both the compressor and motor will stop and the unit will beep (press any
button to stop the beeping sound). The full water tank indicator light will also start flashing.
To resume cooling, empty the reservoir by following these steps:
1. Turn off the air conditioner and unplug it
from the wall socket. To prevent water
leakage, avoid moving the unit when full.
2. Place a container (such as a small pan)
underneath the drain hole.
3. Remove the drain knob & rubber plug from
the drain hole and allow the water to drain
out.
4. When the container is almost full, replace
the rubber plug in the drain hole and empty
the water tray.
5. Repeat until the unit is emptied.
6. Replace the rubber plug and make sure it is
firmly in place.
7. Turn the unit back on. The full tank indicator
light should turn off.
For Continuous Drainage:
• Remove the drain knob and rubber plug
from the drainage port and hold on to them
for future use.
• Connect the drain tube to the water outlet
as shown. Place the other end of drain
tube into a drain.
10