Instructions / Assembly

38
8
10
11
9
9
2”
2”
2”
2”
2”
2”
Referencing your design layout, align the
next cabinet to be installed accordingly.
Fix both cabinets together to prevent movement using a c-clamp. Drill in four Ø4x30mm chip
board screws at all corners by leaving a gap of 2inches from the edges to attach cabinets
together.
Referencing the pre marked locations,
drill pilot holes into each wall stud using a
5/32” drill bit. Screw in the cabinet to the
wall stud using the Ø6x70mm Lag screws
provided.
Mark a position for pilot hole at the
vertical center of the back panel, aligned
with the wall stud.
Placing a level on the cabinet front to
back, level the cabinet by rotating the
feet. Repeat this step with the level left to
right. The cabinet should be level along
all edges and aligned with the adjacent
cabinet.
12
Corner Layout Installation
Installation of Base Cabinets