Instructions / Assembly

13
Preparing your Room
• Locate the uneven areas to adjust the cabinets in order to make the installation plumb, true and
square.
• Using a carpenter’s level, nd the high point of the oor.
• Check all around the room within 24” of the wall where base cabinets will be attached.
• From the high point, mark a level horizontal line using a straight edge, on the walls where the
cabinets will be attached. This will be called the base level line.
• From the base level line, measure up 34 3/4” and mark another level horizontal line for the base
cabinets.
• Add 1-1/4” for a standard NewAge countertops (if you are using a custom countertop, measure
the thickness accordingly) and 18 inches for a standard backsplash. Mark the bottom line for wall
cabinets at this 54-inches from the base line which will serve as a guide for hanging the cabinets.
Plumb Line
Corner is out of plumb
Mark top line for
wall cabinets
Refernce line for
wall rails
Mark rst line at
34.75 inches for
cabinets.
High points on
oor.
Base level line
Plumb Line
Mark bottom line for
wall cabinets
54”
36”
1.25”
30” or 36”
2 3/8”
1.25”
for Granitetop
• Mark the top line for wall cabinets at 30” or 36” (according to the height of wall cabinets selected)
from the bottom line for wall cabinets.
• Mark a reference line 2 3/8” below the measured top line of the wall cabinet. This Line acts as a
reference to install suspension rails on the wall.
Room Preparation