Installation Guide
Table Of Contents
- NEWAGE PRODUCTS INC. OUTDOOR KITCHEN PLATINUM PIZZA OVEN MANUFACTURER WARRANTY
- Safe Operating Practices
- Parts Supplied
- Tools Needed
- Product Inspection
- Product Specifications
- Installing Pizza Oven on NewAge Cabinet & Carts
- Installing Pizza Oven on custom built cabinet
- Assembling the Pizza Oven
- Leak Testing Instructions
- Fixing a Gas Leak
- Connection to AC
- Optional Accessories
- Pre-Operating Checklist
- Operating the Pizza Oven
- Proper Burner Position and Operation
- Pizza Oven Maintenance and Cleaning
- Troubleshooting
- Electrical Wiring Diagram
- Exploded View and Spare Parts
- GARANTIE DU FABRICANT DU FOUR À PIZZA PLATINUM OUTDOOR KITCHEN
- Pratiques d’exploitation sûres
- Pièces fournies
- Outils requis
- Inspection du produit
- Spécifications du produit
- Installation d’un four à pizza sur un meuble et un chariot NewAge
- Installation d’un four à pizza sur un meuble construit sur mesure
- Assemblage du four à pizza
- Instructions de Test d’Étanchéité
- Réparer une fuite de Gaz
- Connexion au CA
- Accessoires optionnels
- Liste de contrôle préfonctionnement
- Liste de contrôle préfonctionnement
- Utilisation du four à pizza
- Position et fonctionnement corrects du brûleur
- Entretien et nettoyage du four à pizza
- Remplacement des ampoules
- Dépannage
- Schéma de câblage électrique
- Vue éclatée et pièces de rechange
39
Proper Burner Position and Operation
CAUTION
Proper placement of each burner is critical after cleaning they must be centered on the brass
orice, resting level without any rocking. Failure to meet these conditions may cause a very
dangerous condition that can cause personal injury and property damage.
Gas control knobs should be in the ‘OFF” position, and fuel line should be disconnected from gas valve
manifold. To reduce the chance of FLASHBACK, the procedure below should be followed at least once
a month or when your Pizza Oven has not been used for an extended period of time.
1. Check burner installation by ensuring that
the valve orifice body is securely inserted
into the end opening of the burner tube. (See
Image 1)
2. To check for proper flame. Turn burner on
high and compare to (See image 2) for proper
flame consistency.
Burner Position
Valve with orice
Proper Flame
Improper Flame
1/2” (13mm) Flame Height
LIGHT BLUE
DARK BLUE
SPUTTERING
FLAME
BURNER
BURNER PORT
Image 1
Image 2
Adjust the air shutter to
achieve the proper flame.