User Guide
94
7) Replace the screw cap in the vent adapter when combustion testing is complete.
8) Cycleboileratleastvetimesatthenalthrottlesettingtoensureburnerigniteswithoutdelayandwithoutnoise.
9) Verify that the gas inlet pressure is between the ranges shown in Table A.4 with all gas appliances (including the converted
boiler) both on and off.
10) A sheet of yellow labels is provided in the envelope with this manual for boilers converted from natural to LP gas. Select the
model from this sheet of labels and apply them as follows:
a. Apply the “Rating Plate Label” adjacent to the rating plate.
b. Apply the “Gas Valve Label” to a conspicuous area on the gas valve.
c. Apply the “Boiler Conversion Label” to a conspicuous surface on, or adjacent to, the outer boiler jacket. Fill in the
date of the conversion and the name and address of the company making the conversion with a permanent marker.
11) Refer to the “Start-up and Checkout” section of the boiler installation manual and perform any checks not already completed.
WARNING
• The throttle adjustments shown in Table A.2 are approximate. The nal throttle setting must be
found using a combustion analyzer. Leaving the boiler in operation with a CO level in excess of
200PPM air-free could result in injury or death from carbon monoxide poisoning. Leaving the boiler
in operation with a CO
2
level outside of the range shown in Table A.3 could also result in injury or
death from carbon monoxide poisoning, even if the boiler is operating at an air-free CO level below
200PPM during this adjustment procedure.
• If the throttle is very far out of adjustment on the “rich” (counter-clockwise) side, the boiler
burner may be running at 0% excess air or even with air deciency. Operating the boiler in this
condition may cause property damage, personal injury or loss of life. Under these conditions
most combustion analyzers used in the eld will show 0% O
2
and a very high (well over 1000 ppm)
CO. Combustion readings will also appear to be unresponsive to throttle adjustment. If the boiler
appears to be operating under this condition, turn the throttle screw clockwise until the ame
lengthens signicantly and is mostly blue. Then, slowly turn the throttle counter-clockwise, using a
combustion analyzer to achieve the required CO
2
as described in Step 6.