Installation & Assembly

4. Place the faucet into its respective hole on the sink/vanity.
5. Place black semi-circle washer over screws sticking out from the bottom of the faucet. Then place the metal
semi-circle washer over the screws sticking out from the bottom of the faucet. Screw the 2 bolts onto the
screws to keep the semi-circle washers in place. Do not screw too tight as is may cause damage to the vanity
top and/or sink.
6. Remove 4 screws to open the power pack and install 4 AA batteries.
7. Close the power pack by reinstalling the screws and hang the power pack where appropriate under the
sink/faucet. Plug in the red wire into the power pack.
8. Attach the loose ends of the hose to their respective water source and turn on water.
9. ***Batteries not included***
***Requires 4 AA Batteries***