Installation & Assembly

8. Put the faucet stem into its designated (center) hole in vanity and from under the sink,
attach rubber gasket, steel washer, and brass nut with 2 tightening screws in the same
manner as for the water-on/off handles. Screw only finger tight.
9. From under the sink, screw the brass Tee onto the bottom of the faucet stem.
10. From under the sink, attach the hoses from the water-on/off handles to the
appropriate ends of the brass Tee, which connects the handles to the faucet.
11. From under the sink, attach the longer hoses to the longer brass fitting at the bottom of
each water-on/off handle, and attach the other end to the water valves.
12. From under the sink, with a Phillips screwdriver, tighten the tightening screws until
firm, but not too tight. Over-tightening can damage the vanity top.