User's Manual

ManualsBrandsNew Centurion Solutions ManualsElectronicsHANDHELD SECURITY DEVICE

THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE

REPRODUCED OR DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER

POSSESSES DIRECT, WRITTEN AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.

Elliott Tech, LLC

HUB Installation Manual

HUB

New Centurion Solutions

Project Number: 776

Reference: 776-91-05-REV-HUB_INSTALLATION_MANUAL.docx

Original Document: March 1, 2011

Revision A: March 16, 2011

Prepared for:

Prepared by:

New Centurion Solutions, Inc.

Greg Williams

3011 Spring Garden St.

Suite E

Greensboro, NC 27403

(336) 617-5410

GWilliams@newcenturionsolutions.com

Elliott Tech, LLC

346 Raleigh Street

Holly Springs, NC 27540

(919) 342-6899

(888) 631-1795 Fax

s.elliott@elliotttech.com

Summary of content (6 pages)

PAGE 1
Elliott Tech, LLC HUB Installation Manual HUB New Centurion Solutions Project Number: 776 Reference: 776-91-05-REV-HUB_INSTALLATION_MANUAL.docx Original Document: March 1, 2011 Revision A: March 16, 2011 Prepared for: New Centurion Solutions, Inc. Greg Williams 3011 Spring Garden St. Suite E Greensboro, NC 27403 (336) 617-5410 GWilliams@newcenturionsolutions.com Prepared by: Elliott Tech, LLC 346 Raleigh Street Holly Springs, NC 27540 (919) 342-6899 (888) 631-1795 Fax s.elliott@elliotttech.
PAGE 2
HUB Installation Manual 776-91-05-REV-A_HUB_INSTALLATION_MANUAL.docx Revision Page Rev A Description FCC Notification Section 3 THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC. AND SHALL NOT BE REPRODUCED OR DISCLOSED IN WHOLE OR IN PART FOR ANY DESIGN OR MANUFACTURE EXCEPT WHEN SUCH USER POSSESSES DIRECT, WRITTEN AUTHORIZATION FROM NEW CENTURION SOLUTIONS, INC.
PAGE 3
HUB Installation Manual 776-91-05-REV-A_HUB_INSTALLATION_MANUAL.docx Contents 1. Equipment List ......................................................................................................... 4 2. Installation Instructions .......................................................................................... 5 3. FCC Notification ......................................................................................................
PAGE 4
HUB Installation Manual 1. 776-91-05-REV-A_HUB_INSTALLATION_MANUAL.docx EQUIPMENT LIST A. USB Cable, Type A to Type B (1) B. Hub Assembly (1) C. Flexible ½ wave center-fed dipole antenna D. HUB Power Supply (1) with articulated knuckle (1) E. Personal Computer (PC) (1) F. U.L. approved power cord, 6 ft. length (1) THE INFORMATION CONTAINED HEREIN IS PROPRIETARY TO NEW CENTURION SOLUTIONS, INC.
PAGE 5
HUB Installation Manual 2. 776-91-05-REV-A_HUB_INSTALLATION_MANUAL.docx INSTALLATION INSTRUCTIONS To begin, check the parts available against the equipment list, identifying any missing parts. If all parts are accounted for, proceed to the instructions below to begin installing the HUB. Step 1: Identify the Flexible ½ wave center-fed dipole antenna with articulated knuckle (C). Screw the antenna into the gold coaxial antenna connector on the front panel of the HUB assembly (B).
PAGE 6
HUB Installation Manual 776-91-05-REV-A_HUB_INSTALLATION_MANUAL.docx Step 3: Identify the HUB Power Supply (D). Plug the barrel jack plug into the mating barrel jack on the front panel of the HUB assembly (B). Plug the U.L. approved power cord, 6 ft. length (F) into the HUB Power Supply (D). Only one end will mate with it properly. Plug the other end of the power cord into a standard 120 Volt wall outlet. The green light on the front panel of the HUB should illuminate.