Operation Manual

NZR 1.5 A1

│

7 ■

♦ Remove all packaging material.

Power supply

♦ Use a 1.5V battery 6 to operate the appliance.

To insert the supplied battery 6 proceed as follows:

1) Carefully pull the housing 7 oﬀ the hand set 4

and place it to one side.

2) Insert the battery 6. Pay attention to the polarity

markings given in the battery compartment.

3) Push the housing 7 back onto the hand set 4until it sits

ﬁrmly in place and the gap is fully closed. The anti-slip

dimples on the housing 7 must be on the same side as

the anti-slip dimples on the hand set 4. The writing on

the housing 7 must be on the same side as the operat-

ing button 5.

NOTE

► If the eﬀectiveness of the cleaning starts to decrease, the

battery 6 needs to be replaced.

Handling and use

This section provides important information about proper hand-

ling and operation of the appliance.

Fitting the cleaning attachment

1) Remove the appliance head 1 by turning it slightly so

that the dot on the appliance head 1 is aligned with the

symbol on the hand set 4. Then pull the appliance

head 1 upwards and oﬀ.

2) Push the attachment ﬁtting 3 into the hole of one of the

cleaning attachments 2 in the storage box 8. You will

feel a slight click.

3) Pull the hand set 4 away from the storage box 8. The

cleaning attachment 2 comes out of the storage box 8.

4) Check that the cleaning attachment 2 is ﬁrmly attached

to the attachment ﬁtting 3. If necessary, push the cleaning

attachment 2 onto the attachment ﬁtting 3 with slightly

more force.

IB_290413_NZR1.5A1_DK.indb 7 19.05.17 11:53