Operation Manual

NZPS 3 A1

│

7 ■

NOTE

► Check the package for completeness and signs of visible damage.

► If the delivery is incomplete or damage has occurred as a result of defective

packaging or during transport, contact the Service hotline (see section Service).

♦ Remove all parts of the appliance and the operating instructions from the carton.

♦ Remove all packaging material.

Power supply

♦ Use two 1.5V batteries q to operate the appliance. To insert the supplied

batteries q proceed as follows:

1) Carefully twist the housing 4 anticlockwise oﬀ the hand element 5 and place it

to one side.

2) Insert the batteries q. Pay heed to the correct polarity markings given on the

housing 4.

3) Push the housing 4 back onto the hand element 5.Turn the housing 4

clockwise to tighten it.

NOTE

► If the polishing eﬀect diminishes, the batteries q must be replaced.

Handling and use

This section provides important information about proper handling and operation

of the appliance.

Attaching the polishing cap

♦ Place the shaft of the polishing cap 2 onto the attachment thread 1. Turn the

polishing cap 2clockwise while pressing down the catch

6 to tighten it.

Removing the polishing cap

NOTE

► Remove the polishing cap 2 when it no longer delivers the required polishing

result.

♦ Press down the catch

6 while turning the polishing cap 2 anticlockwise.