Operation Manual
NZPS 3 A1
■ 6
│
GB
│
IE
│
NI
Power supply
♦ Use two 1.5V batteries - to operate the appliance. To insert the supplied batteries -
proceed as follows:
1) Carefully twist the housing anticlockwise off the hand element and place it to one
side.
2) Insert the batteries -. Pay heed to the correct polarity markings given on the housing .
3) Push the housing back onto the hand element .Turn the housing clockwise to
tighten it.
NOTE
► If the polishing effect diminishes, the batteries - must be replaced.
Handling and use
This section provides important information about proper handling and operation of the
appliance.
Attaching the polishing cap
♦ Place the shaft of the polishing cap onto the attachment thread . Turn the polishing
cap clockwise while pressing down the catch
to tighten it.
Removing the polishing cap
NOTE
► Remove the polishing cap when it no longer delivers the required polishing result.
♦ Press down the catch
while turning the polishing cap anticlockwise.
Polishing teeth
NOTE
► We recommend using the appliance in front of a mirror so that you can guide the ap-
pliance more confidently and avoid injuring your gums.
► It is normally sufficient to use the appliance twice a week. Use of the appliance does
not replace daily brushing with a toothbrush.
► Do not use appliance on your gums.
1) Add a little standard commercial toothpaste or a special polishing toothpaste to the
polishing cap . Use the polishing cap to spread the toothpaste onto the area to
be polished.
2) Press the operating button
. The polishing cap starts moving.
3) Move the appliance in a circular motion up and down to polish the tooth. Polish each
tooth for approx. 20–30 seconds.
4) Release the operating button
when you want to stop cleaning. The appliance
stops.