Operation Manual

NSZB 3.7 B3
■ 6
│
GB
│
IE
│
NI
6) Start in one quadrant:
Start with the brush head 1 on your gums, and move the brush upwards/
downwards from the gums to the crown of the tooth.
Continue in this manner on both the inside and the outside of the tooth.
Start again at the gums for each individual tooth.
Do not forget to brush the back of the rear molars.
To clean the chewing surfaces, guide the brush over them with a little
pressure.
7) After 30 seconds, the toothbrush stops briefly to signal that you should
start cleaning the next quadrant. Clean each jaw quadrant using the same
technique.
8) After two minutes, the toothbrush stops briefly 2 times. This informs you
that you have complied with the dental recommendation of two minutes
cleaning.
9) Press the on/off switch 0 repeatedly until the toothbrush stops.
10) Then take the toothbrush out of your mouth.
11) After use, rinse the brush head 1 thoroughly under running water.
12) Remove the brush head 1 from the handset.
To clean the drive shaft 2 and the handset, hold them under running wa-
ter for a short while. Hold the handset so that the drive shaft 2 is pointing
downwards at an angle.
NOTE
Massage your gums regularly. This promotes blood circulation and helps to
keep them healthy. Set the mode to "Pulse" and guide the moistened brush
over your gums with a light pressure.
Cleaning with the interdental brush
You can use the interdental brush r to clean the interdental spaces, difficult-
to-access parts on the teeth, or the chewing surfaces of your molars.
1) Attach the interdental brush r to the hand element.
2) Moisten the interdental brush r under running water.
3) Put a little toothpaste onto the wet interdental brush r.
NOTE
To avoid splashes, do not switch on the appliance until it is in your mouth.
4) Use the On/Off switch 0 to select the desired operating mode and clean
the required area.
5) Press the On/Off switch 0 repeatedly until the appliance stops.
6) Then take the interdental brush r out of your mouth.
7) After use, clean the interdental brush r thoroughly under running water.
8) Remove the interdental brush r from the hand element.
To clean the drive shaft 2 and the handset, hold them under running water
for a short while. Hold the handset so that the drive shaft 2 is pointing
downwards at an angle.
NOTE
The interdental brush r is ideal for cleaning braces or false teeth.