Operation Manual

DAZD 3.7 Li B2
GB
│
IE
│
NI
│
5 ■
First use
NOTE
Before starting to use the appliance, check that
it is in fault-free condition. If it is not, it must not
be used.
1) Insert the plug into the mains power socket.
2) Before initial use, clean the new brush heads 
with fresh water.
3) Open the lid  of the charger  and place
the replacement brush heads on the brush
holders. Re-close the lid .
4) Place the handset on the charger  so that
it slides onto the pin on the base.
5) Allow the handset to charge up for around
14 - 16 hours before using it for the first
time. The charge indicator  on the front of
the hand appliance lights up red during the
charging process.
6) Use the handset repeatedly without charging
the battery until the performance becomes
noticeably weaker or the toothbrush stops
working and the charge indicator  blinks red.
Then recharge the battery for 14 - 16 hours.
When the appliance is fully charged, the
charge indicator  lights up green.
7) Charge and discharge the toothbrush com-
pletely 3 times. The battery will have then
reached its full capacity.
8) You can now leave the handset in the char-
ger  after every use, so as to always have
full power available.
Fitting / removing brush heads
■ When fitting the brush head , attach it
straight and with the bristles facing forwards
towards the handset.
■ To remove the brush head , pull it upwards
and off.
NOTE
For information on ordering replacement brush
heads, read the section „Ordering replacement
parts“.
You can also use the replacement brush heads
from Oral-B
®
* electric toothbrushes for this
appliance (except Pulsonic models).
* Oral-B is a registered trademark of Procter &
Gamble Co.