Operation Manual

DAZD 3.7 Li B2
GB
│
IE
│
NI
│
7 ■
7) After 30 seconds, the toothbrush stops briefly
to signal that you should start cleaning the
next quadrant. Clean each jaw quadrant
using the same technique.
8) After two minutes the toothbrush stops its
operation briefly 4 times. This informs you that
you have complied with the dental recommen-
dation of two minutes cleaning.
9) Press the On/Off switch  repeatedly until
the toothbrush stops.
10) Then take the toothbrush out of your mouth.
11) After use, rinse the brush head  thoroughly
under running water.
12) Remove the brush head  from the handset.
To clean the drive shaft and the handset,
allow a little water to flow over them. Hold
the hand-set so that the drive shaft is pointing
downwards.
NOTE
Regularly massage your gums. This promotes
blood circulation and helps to keep them healthy.
Set the mode to "Pulse" and guide the moistened
brush over your gums with a light pressure.
Travel lock
When you store the toothbrush or wish to prevent
it from switching on accidentally, you can activate
the travel lock. The toothbrush cannot then be
switched on by simply pressing the On/Off switch .
■ To activate the travel lock, press and hold
the On/Off switch  until the travel lock
indicator
 flashes green 5 times in a row.
The On/Off switch  is now locked.
If you now attempt to switch on the toothbrush
by briefly pressing the On/Off switch , the
travel lock indicator
 flashes green 5x to
show that the travel lock is activated.
■ To deactivate the travel lock, press and hold
the On/Off switch  until the travel lock
indicator
 lights up 1x for a couple of
seconds. The travel lock is now deactivated
and you can start the appliance normally.
Cleaning and care
DANGER – ELECTRIC SHOCK!
►
Always remove the plug of the charger 
from the power socket before cleaning the
appliance! Risk of electric shock!
Never submerge the handle or the
charger  in water or other liquids.
NOTE
Never open the housing of the charger  or
the toothbrush! They cannot be resealed in a
water-tight manner.
1) Clean the charger  only with a soft, lightly
moistened cloth. Do not use detergents or sol-
vents. They can damage the plastic surfaces.
2) Remove the brush head  from the handset.
After use, clean the brush heads  thoroughly
under running water. We recommend cleaning
the brush heads  in a standard commercial
denture cleaning fluid every 2 - 4 weeks. A new
brush head  should be fitted after about
3 months, and the brush head must always
be replaced when the bristles start to bend
outwards.