Quickstep

6
HOW TO SET IT UP?
1
Connect the audio lines as required (e.g.
audio source to the MIC IN channels; AES/EBU to
AES/EBU channels and audio destination to the
LINE OUT; AES/EBU channels)
2
Next, enable the Dante and power connection
via the etherCON
®
chassis connector. Connect
the NA2-IO-DPRO to an Ethernet switch which
supports PoE. If PoE is not supported by the
switch in use, deploy an external midspan PoE
power injector. For Daisy-Chaining (Switched mode)
use only a PoE injector with no classification.
3
Configure the audio routing in
Dante
®
controller. This is software provided by Audinate,
free of charge.
4
Finally, adjust your audio parameters, Phantom
power, PAD, and high-pass filtering in the DPRO
Controller software, available for PC and Mac on
the Neutrik website, free of charge. You can also
save and recall presets in this software.
DPRO Controller by Neutrik (www.neutrik.com/
en/support/downloads)
APP REQUIREMENTS
• RAM min 2 GB
• Display resolution > 1280 x 1024 pixel
• Windows 7 or later
• MAC OS 10.12 or higher
For Dante related questions, refer to the Audinate web site: www.audinate.com.
The Audinate web site features a wealth of manuals, teaching material, FAQs and videos.