Quick Start Guide
©NeuroTek 2021 Version 2.0
Edit Proles
To edit the proles, you would want to have all your
accessories (the pulsers, headset, and EyeScan, if applicable)
connected to the Tac in order to adjust the settings for all
devices. Once they are connected, you would follow the
following steps:
o
From the main menu, Select Proles
o
You will then see Resource (which is set at slower
speeds) and Reprocessing (which is set at higher speed).
Select Edit next to the one you want to change, and then
select Start.
o
It will walk you through the settings for each device,
(pulsers, headset, and EyeScan if applicable).
o
Once completed, press Save and your changes should be
saved at this point.
o
From the main menu, select the prole that you made
changes to, Resource or Reprocessing and then Start,
and you should see the changes in your prole.
7