Installation Guide

Step 5

NOTE: Make sure the label on the CT is

facing the utility (where the power comes

from) and not the breaker panel.

2 ) Loop the CTs around each of the

main power lines and attach the

bracket to the CT again.

1 ) Remove the top bracket of the CT

by inserting your finger through

the loop and pulling towards you.

OFF

NEED HELP? Having troubles trying to figure out which phase a CT is on?

Visit support.neur.io for tips.

3 ) Insert the connector from the CT that's on the

same phase as the black Neurio voltage wire into

port labeled (1). Then insert the connector from

the second CT into the port labeled (2).

CAUTION: Be

sure to take care

to not touch the

exposed main line connections

to the main breaker.