Installation Guide

Step 8
You're almost done. Replace the covers on your panel.
Make sure to place the supplied Neurio breaker sticker
next to the breaker that Neurio's black wire is connected to.
Then turn the main breaker back on.
When powered on, Neurio will play the following tones to indicate its status
in sequential order:
If Neurio is conneced to the WiFi network, you should also hear a long chime one minute after the short chime.
ON
If you don’t hear the tune
acknowledging a successful
installation, please visit
support.neur.io for
troubleshooting tips.
TONE INDICATION DESCRIPTION
Short beep Voltage check
One beep for each voltage wire that is connected.
For a 2-phase installation there should be two
beeps to indicate that the black and red wires are
connected.
Falling tone Voltage warning
Indicates that two wires are connected to the
same phase. For a 2-phase installation, this
warning should not be heard. If it is, try moving
Neurio's black or red wire to another breaker.
Falling tone
Neurio failed to
join network
Neurio was unable to join the homeowner’s WiFi
network. Neurio will now start hosting its own
WiFi network again to allow the homeowner
to re-connect to Neurio and re-enter the WiFi
credentals.
Short chime
Neurio's WiFi
network started
Neurio has started hostng its own WiFi network.
The homeowner can join this network to configure
Neurio and connect it to the homeowner’s own
WiFi network.
Long chime
Neurio's joined
network
successfully
Neurio's joined WiFi network sucessfully.