User Manual

6 | KH 310
Installing and connecting the KH 310
CAUTION
Danger of injury and material damage due to tipping/dropping of the product!
If improperly mounted, the product and/or the mounting hardware (e.g. rack) can tip over
or drop down.
X
Always have the product mounted by a qualified specialist according to local, national
and international regulations and standards.
X
Use the mounting systems recommended by Neumann and always provide sucient
additional protection against tipping or dropping!
CAUTION
Damage to the product due to overheating!
If air cannot circulate properly around the cooling fins on the rear of the product, the
amplifier(s) may overheat leading to premature activation of the thermal protection system
which limits the maximum output level of the loudspeaker. In rare cases, damage to the
product may also occur.
X
Never cover the cooling fins.
X
When installing the product into tight spaces such as wall recesses, maintain an air gap
of at least 5 cm (2") around the rear of the product and provide sucient air circulation.
If necessary, use forced-air cooling (e.g. in OB vans).
It is not possible to remove the electronics panel and locate it remotely.
For information on installation, please refer to the supplied “Getting Started Quickly”
supplement. This will help you set up the loudspeakers in a way that will give you the
best acoustic performance from the system.
For further information on setting up loudspeakers, please refer to the “Questions &
Answers” section on the product page at www.neumann.com.
For more information on building systems using Neumann loudspeaker products, please
refer to the “Product Selection Guide” at www.neumann.com
Preparing the loudspeakers
CAUTION
Risk of staining surfaces!
Some surfaces treated with varnish, polish or synthetics may suer from stains when they
come into contact with other synthetics. Despite a thorough testing of the synthetics used,
we cannot rule out the possibility of staining.
X
Do not place the KH 310 on delicate surfaces.
CAUTION
Danger of damaging the midrange and bass drivers!
If the KH 310 is placed face down on a soft surface or if the front panel of the KH 310 is
pressed against your body when you carry it, the drivers can be damaged.
X
Never place the KH 310 on a soft surface with the front panel facing downwards.
X
Always carry the KH 310 so that the front panel is facing upwards.
You can use the handles B on the rear panel to lift the loudspeaker.
To place the loudspeaker on a flat surface:
X
Attach the supplied self-adhesive feet to the bottom of the cabinet.
This reduces the risk of scratching the surface and acoustically isolates the loudspeaker
from the surface.
EN